Pure Aluminium Plate Sheet

Basic Instruction

Aluminum plate is significantly applied in products with low strength requirements. Products are normally applied in signboards, billboards, building appearance decoration, bus body, wall decoration of high-rise houses and factories, kitchen sink, lamp holder, fan blade, virtual parts, chemical instruments, sheet metal processing parts, deep drawing or spinning concave utensils, welding parts, heat exchangers, clock ground and disk ground, nameplates, kitchenware, decorations, reflective appliances, etc.

Specification

Component

Material name: aluminum and aluminum alloy extruded bar (≤ 150mm, h112, T6, O state) standard: GB / T characteristics and scope of application: ① 5052 is an Al Mg alloy, which is widely used, especially in the construction industry. It is the most promising alloy. Good corrosion resistance, excellent weldability, good cold workability and medium strength. The main alloy element of 5052 is magnesium, which has good forming and processing performance, corrosion resistance, weldability and medium strength. It is used to manufacture aircraft fuel tank, oil pipe, sheet metal parts of traffic vehicles and ships, instruments, street lamp supports and rivets, hardware products, electrical shell, etc. ② Al Mn alloy is the most widely used antirust aluminum. This alloy has high strength, especially fatigue strength: high plasticity and corrosion resistance, can not be strengthened by heat treatment, good plasticity in semi cold work hardening, low plasticity in cold work hardening, good corrosion resistance, good weldability, poor machinability and polishing. It is mainly used for low load parts that require high plasticity and good weldability and work in liquid or gas medium, such as mailbox, gasoline or lubricating oil conduit, various liquid containers and other low load parts made by deep drawing: wire rod is used to make rivets. Guangyue metal 5052 aluminum plate

1. Cracks, corrosion spots and traces of nitrate are not allowed on the surface.

2. Peeling, bubbles, surface roughness and local mechanical damage with the depth not exceeding 8% of the nominal wall thickness of the defect location are allowed on the surface, but the maximum depth of the defect shall not exceed 0.5mm, and the total area of the defect shall not exceed 5% of the total area of the plate.

3. The supplier is allowed to polish the profile longitudinally until the surface is smooth.

4. The supplier has its own requirements and other requirements